Polycom SoundStructure C16 Design Manual page 337

Provisioning Server Settings
Name Possible Values
Retry Wait (s) 0 to 300 seconds
Tag SN to UA Enable or Disable
The DHCP boot server settings are only accessible when the DHCP client is enabled. The Boot server
parameters are described in the following table.
DHCP Boot Server Settings
Name Possible Values
Boot server Static (default)
Custom
Polycom, Inc.
Description
This setting specifies the minimum amount of time that must
elapse between starting a new file transfer and retrying a file
transfer. You can specify a value from 0 to 300 seconds. The
default is 1 second.
This setting specifies whether the SoundStructure VoIP
Interface's serial number (MAC address) is included in the
User-Agent header of any HTTP or HTTPS provisioning request.
When enabled, the MAC address is present, when disabled, it is
not. The default is disabled.
Description
The SoundStructure VoIP Interface will use the boot
server/provisioning server configured manually through the
Server options.
The SoundStructure VoIP Interface will look for the option
number specified by the boot server option parameter and the
type specified by the boot server option type in the response
received from the DHCP server.
If the DHCP server sends nothing, the following scenarios are
possible:
• If a boot server value is stored in flash memory and the value
is not 0.0.0.0, then the value stored in flash is used.
• Otherwise the SoundStructure VoIP Interface sends out a
DHCP INFORM query.
If a single alternate DHCP server responds, this is functionally
equivalent to the scenario where the primary DHCP server
responds with a valid boot server value.
If no alternate DHCP server responds, the INFORM query
process will retry and eventually time out.
337