Polycom SoundStructure C16 Design Manual page 583

Examples
Command
Select Ring Tone For Telephony
Argument Argument value
Channel Type Virtual Channel
Value Type Sequence
Read/Write Mode Read/Write
Phys Chans Analog Telephony Input, VoIP Telephony Input
Virt Chans Mono
System Limits Minimum: 1, Maximum: 14
Default 1
Event Source No
Description
This parameter selects the type of ring tone to be generated for the telephony interface. If ring tones are
enabled, the selected tone is played whenever there is an incoming ring signal on the telephony interface.
The parameter values correspond to the following tones.
● 1: normal ring
● 2: low trill
● 3: low double trill
● 4: medium trill
● 5: medium double trill
● 6: high trill
● 7: high double trill
● 8: highest trill
● 9: highest double trill
● 10: beeble
Polycom, Inc.
Response
val phone_ring
"Phone In" 1
Interface—phone_ring_tone
Description
Returns the value 1 when the incoming phone line
associated with the virtual channel "Phone In" is ringing.
Note that the phone in virtual channel name must be
used, not the phone out virtual channel name.
583