Install Plug-in Cards
Remove any existing plug-in cards that were replaced with the Upgrade Plug-in Card Tool and replace with
the new plug-in cards. The following figure shows a SoundStructure TEL1 being replaced with a
SoundStructure VoIP Interface.
SoundStructure TEL1 Replaced with a SoundStructure VoIP Interface
Connect Network to the SoundStructure VoIP Interface
Connect the network interface of the SoundStructure VoIP Interface to the appropriate VoIP network as
shown in the following figure.
Connecting SoundStructure VoIP Interface to VoIP Network
Power Up the System
Once the plug-in cards are properly installed, plug-in the power cord to the devices. Unless the system is in
a factory-fresh state, after the system has finished booting, it will have a solid yellow front panel LED to
indicate that the configuration file that is loaded does not match the hardware. To correct the yellow front
panel LED status you will upload the proper configuration file in the next step.
Polycom, Inc.
325