Removing Presets - Polycom SoundStructure C16 Design Manual

Hide thumbs Also See for SoundStructure C16:

Table of Contents

Partial Presets

Partial presets generate command acknowledgments for all parameters that are changed during the

execution of the preset. The outputs of the system are not muted during a partial preset unless the designer

explicitly inserts commands to mute the outputs of the system during the partial preset.

Once the full preset has finished running, a 'ran' command acknowledgment is generated as shown next

where "Partial Preset" would be replaced with the name of the partial preset that was executed.

ran "Partial Preset"

Full preset execution does not generate any command acknowledgments from the

SoundStructure system. If specific parameters are required after a preset has been

executed, the values for the parameters should be queried after a preset has

The outputs of the system are muted during the execution of a full preset. The

outputs are unmuted after the preset has executed. This muting does not affect the

state of the safety mute or any other mute parameter.

Removing Presets

Presets may be removed from the system by left clicking on the preset and then clicking Remove Preset.

If the power-on preset is removed and the system rebooted, the system boots into the current settings if they

have been stored in the configuration file.

Polycom, Inc.