Polycom SoundStructure C16 Design Manual page 351

VoIP Network Settings
Select either Automatic Configuration (DHCP) or Manual Configuration for configuring the IP address of the
SoundStructure VoIP Interface as described in the following table.
IP Address Settings
Name Possible Values
Address Mode Automatic Configuration
(DHCP) (default)
Manual configuration
If you select the Manual configuration option, you must enter the information for the following fields to
properly configure the IP address of the SoundStructure VoIP Interface.
IP Address Settings
Name Possible Values
IP Address Dotted-decimal IP address
Netmask Dotted-decimal subnet mask
Gateway Dotted-decimal IP address
DNS 1 Dotted-decimal IP address
DNS 2 Dotted-decimal IP address
VLAN ID -1, or 0 to 4095
DHCP Boot Server Settings
If you are using DHCP to set the IP address of the SoundStructure VoIP Interface, then the DHCP server
can also supply additional settings to the SoundStructure VoIP Interface to simplify setup and configuration.
Enter the parameters described in section
Provisioning Server Settings
If you are using a central provisioning server or temporarily setting up a manual FTP server for a firmware
update, you may enter the server information on this page including the type of access to the provisioning
server, the server address, username, and password information as shown in the following table.
Polycom, Inc.
Description
The SoundStructure VoIP Interface expects to receive an IP
address from the network DHCP server. If you select
automatic configuration then the manual fields are grayed
out and are not accessible.
You will need to manually set the SoundStructure VoIP
Interface's IP address including the IP address, netmask,
gateway, and optional DNS servers.
Description
Enter the IP address to be used for the SoundStructure VoIP
Interface. This IP address should be unique to the
SoundStructure VoIP Interface.
Enter the subnet netmask to be used with the IP address.
Typically this is equal to 255.255.255.0.
Enter the IP address of the router that is the address the
SoundStructure VoIP Interface will go to when seeking IP
addresses outside of the local subnet.
Enter the IP address of the primary domain name server.
Enter the IP address of the secondary domain name server.
Set the VLAN ID to -1 to indicate no VLAN ID, or to the value
of the desired VLAN ID.
Setting the Provisioning Server Information.
351