Mitsubishi Electric MELSERVO-J4 Series Instruction Manual page 389

For the servo amplifier with a battery holder on the front
• Removal procedure
CAUTION
• Pulling out the connector of the battery without the lock release lever pressed may damage the CN4 connector of the servo amplifier or the connector of the
battery.
Install a battery, and route the battery
cable along the right side of the
battery.
When connecting the encoder
cable to CN2 or CN2L
connector, prevent the battery
cable from being pinched.
Install a battery, and connect the plug to
the CN4 connector.
While pressing the lock release lever,
pull out the connector.
Press down the lock release lever, and
slide the battery toward you.
11 OPTIONS AND PERIPHERAL EQUIPMENT
11
387
11.8 Battery