Power Supply Capacity - Mitsubishi Electric MELSERVO-J4 Series Instruction Manual

Power supply capacity

The power supply capacity is the same as that for the AC power supply input.
Page 315 Power supply capacity and generated loss
Selection example of wires
Selection conditions of wire size are as follows.
Construction condition: Single wire set in midair
Wiring length: 30 m or shorter
The following diagram shows the wires used for wiring. Use the wires given in this section or equivalent.
Example of selecting the wire sizes
Use the 600 V grade heat-resistant polyvinyl chloride insulated wire (HIV wire) for wiring. The following shows the wire size
selection example.
Servo amplifier
MR-J4-10GF-RJ
MR-J4-20GF-RJ
MR-J4-40GF-RJ
MR-J4-60GF-RJ
MR-J4-70GF-RJ
MR-J4-100GF-RJ
MR-J4-200GF-RJ
MR-J4-350GF-RJ
*2
MR-J4-500GF-RJ
*2
MR-J4-700GF-RJ
*2
MR-J4-11KGF-RJ
*2
MR-J4-15KGF-RJ
*2
MR-J4-22KGF-RJ
*1 Alphabets in the table indicate crimping tools. For crimp terminals and applicable tools, refer to the following.
 Page 566 Selection example of crimp terminals
*2 To connect these models to a terminal block, be sure to use the screws that come with the terminal block.
Selection example of crimp terminals
Symbol
a
*1
b
c
d
e
f
g
*1 Coat the crimping part with an insulation tube.
*2 Some crimp terminals may not be mounted depending on their sizes. Make sure to use the recommended ones or equivalent ones.
APPX
566
Appendix 1 When using the servo amplifier with the DC power supply input
Wire [mm
L1/L2/L3/N-/
2 (AWG 14)
3.5 (AWG 12)
5.5 (AWG 10): a
8 (AWG 8): b
14 (AWG 6): e
22 (AWG 4): f
38 (AWG 2): g
Servo amplifier-side crimp terminal
*2
Crimp terminal Applicable tool
Body
FVD5.5-4 YNT-1210S
8-4NS YHT-8S
FVD2-4 YNT-1614
FVD2-M3
FVD14-6 YF-1
FVD22-6 YF-1
FVD38-8 YF-1
2 *1
]
Head




YNE-38
YNE-38
YNE-38
L11/L21
1.25 to 2
(AWG 16 to 14)
1.25 (AWG 16): a
2 (AWG 14): d
1.25 (AWG 16): c
2 (AWG 14): c
Manufacturer
Dice

JST



DH-122
DH-112
DH-123
DH-113
DH-124
DH-114