Appendix 9 Analog Monitor - Mitsubishi Electric MELSERVO-J4 Series Instruction Manual

Appendix 9
A voltage of analog monitor output may be irregular at power-on.
The servo status can be output to two channels in terms of voltage.
Setting
Change the following digits of [Pr. PC09] and [Pr. PC10].
[Pr. PC09]
0 0
Analog monitor 1 output selection
(the signal provided to the output across MO1 and LG)
[Pr. PC10]
0 0
Analog monitor 2 output selection
(the signal provided to the output across MO2 and LG)
[Pr. PC11] and [Pr. PC12] can be used to set the offset voltages to the analog output voltages. Setting value is -999 mV to 999
mV.
Parameter
PC11
PC12
APPX
608

Appendix 9 Analog monitor

Analog monitor
Description
This is used to set the offset voltage of MO1 (Analog monitor 1).
This is used to set the offset voltage of MO2 (Analog monitor 2).
Setting range [mV]
-999 to 999