Alarm messages
2 Mbit/s Excessive FAW bit error rate
...................................................................................................................................................................................................................................
Alarm identifier
Information
Alarm category
ASAP
Alarm severity
(default setting)
Reporting state
(default setting)
Local indications
Cause
Actions
Note(s)
...................................................................................................................................................................................................................................
1-24
P12ScEXC
2 Mbit/s signal degrade protected. The block error rate of an incoming 2
Mbit/s signal exceeds an error threshold in a protected configuration (PDH ->
SDH).
Transmission
Prompt
Reported
–
Fault(s) in upstream external cabling or equipment.
Check upstream external cabling and equipment.
Threshold is not provisionable.
Alcatel-Lucent - Proprietary
See notice on first page
365-312-803R7.2
Issue 4, May 2007