Ident' Device Operating Mode (Id No.); Extended Diagnostics Parameters A To P; Partial Stroke Test 'A.\\Pst - Siemens SIPART PS2 Operating Instructions Manual

9.3.2.25

'55.IDENT' Device operating mode (ID No.)

Possible settings:
Purpose:
Description:
Factory setting:
See also
Cyclic data transfer (Page 219)
9.3.3

Extended diagnostics parameters A to P

9.3.3.1

Partial stroke test 'A.\\PST'

A. PST - Partial Stroke Test
Requirement:
Possible settings:
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
● 9710
● 8079
● AdAPT
The positioner identifies two device operating modes with respect to
the response to the DP master of class 1:
● [9710] Vendor-independent profile ID number.
Can be replaced by positioners of other manufacturers complying
with PROFIBUS PA profile 3.0.
● [8079] Device-specific ID number for full functionality.
Complete functional range of the positioner (condition at delivery).
● AdAPT Automatic adaptation by the control system.
A specific GSD file is allocated to every device operating mode. If
the configuration of your PROFIBUS PA path does not match the set
device operating mode, the device cannot accept the cyclic data ex‐
change. The station number and the device operating mode cannot
be modified during ongoing communication with a master of class 1.
You can recognize successful establishment of connection to a cyclic
master in that the positioner responds to the setpoint of the master.
Communication with an acyclic master is indicated by a flashing dec‐
imal point in the top line of the positioner's display.
1
The '50.XDIAG' Activation of extended diagnostics (Page 170) pa‐
rameter is set to 'On1', 'On2' or 'On3'.
● OFF
● On
Parameter assignment
9.3 Description of parameters
173