Siemens SIPART PS2 Operating Instructions Manual page 72

Installing/mounting
4.7 Installing the optional modules
7. Position the ribbon cable of the internal NCS module (D) upwards, as shown in the figure,
8. Slide the internal NCS module (B) under the basic electronics into the rack until you hear
9. An insulating cover is required over the internal NCS module. This insulating cover is
10.Now position the insulating cover by pressing one end against the seat of the rack and
11.Firmly press the other end until the insulating cover is underneath the contact surface of
12.Install the basic electronics back into the positioner.
13.Insert the ribbon cable connector of the internal NCS (D) module onto the positioner basic
14.Using both the screws, fasten the module cover provided. Do not use the standard module
15.Make sure that the ribbon cable is not trapped.
16.Select the labels that already exist on the standard version of the module cover from the
17.Proceed with the corresponding steps in the section General information about the
72
before you slide the internal NCS module into the rack.
it click into place.
supplied with the internal NCS module. Place the insulating cover (C) on one side under
the basic electronics seat of the rack.
slowly lowering the other end.
the basic electronics. The recesses of the insulating cover must fit in the corresponding
webs of the rack.
electronics.
Note for installed position feedback module: Reestablish all electrical connections between
the basic electronics and the position feedback module.
cover of the positioner. The provided module cover has a larger recess to accommodate
the adjustment wheel of the magnet clamp (F).
label set provided. Affix the selected labels on the installed module cover as per the
standard version.
installation of option modules (Page 54).
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB