Installing/mounting
4.2 Mounting the linear actuator
9. Install the mounting bracket
10.Select the row of holes. The selection of the row of holes depends on the yoke width of the
11.Keep the positioner and the fastening bracket on the actuator. Ensure that the carrier pin
44
2 spring lock washers
Figure 4-4
Installation with mounting bracket
Figure 4-5
Installation with mounting bracket, flameproof enclosure
actuator. Select the row of holes in such a way that the carrier pin
②
up bracket
near the spindle. Ensure that the pick-up bracket
③
clamping pieces
.
④
is guided inside the pick-up bracket
①
at the rear side of the positioner. Use 2 hexagon bolts
⑩
and 2 flat washers
②
.
⑪
for this purpose.
④
②
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
⑨
,
meshes with the pick-
does not touch the