Wiring Ncs Sensor To Emc Filter Module - Siemens SIPART PS2 Operating Instructions Manual
Electropneumatic positioners with profibus pa
Hide thumbs
Also See for SIPART PS2:
- Operating instructions manual (372 pages) ,
- Compact operating instructions (294 pages) ,
- Manual (200 pages)
Table of Contents
Advertisement
Connect
5.2 Electrical wiring
5.2.3
Wiring NCS sensor to EMC filter module
Requirement
You need the EMC filter module, article number C73451‑A430‑D23, for the electrical
connection of the accessory part "NCS sensor for contactless position measurement" to the
positioner. The positioner supplies auxiliary power to the NCS sensor via the EMC filter module.
Wiring diagram
①
②
③
④
⑤
⑥
Figure 5-6
86
Positioner (open state)
Vcc: Yellow
Vref: Green
Vpos: Black
Ground: Brown
EMC filter module C73451-A430-D23
Example of connecting the NCS to the EMC filter module
⑦
Cable clamp
⑧
Screw F3x8
⑨
Cable gland
⑩
Four-pole NCS cable
⑪
Non Contacting Sensor (NCS)
⑫
Cable shielding lug
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
Advertisement
Table of Contents
