Overview Of Advanced Diagnostics Parameters A To P - Siemens SIPART PS2 Operating Instructions Manual

Parameter assignment
9.2 Tabular overview of the parameters
Parameter Function
51.FSTY Safety setting
52.FSTI Monitoring period for setting the safety setting
53.FSVL Safety setpoint
54.STNR Station number
55.IDENT Device operating mode (ID No.)
1)
2)
3)
4)
9.2.3

Overview of advanced diagnostics parameters A to P

Introduction
These parameters are used to set the extended diagnostics functions of the positioner.
Note
Factory setting
Factory-set parameter values are printed in bold in the following table.
Note
Display
Parameters A to P and their sub-parameters are only displayed when the extended diagnostics
has been activated in parameter "'50.XDIAG' Activation of extended diagnostics (Page 170)"
with setting "On1", "On2" or "On3".
150
Parameterized safety setpoint
Last setpoint
Open vent valve
Vendor-independent profile ID num‐
ber
Device-specific ID number for full
functionality
Automatic adaptation by the control
system
Setpoint turning points only appear when '9.SFCT = FrEE' is selected.
"Normally closed" means: Operation when a switch is open or Low level
"Normally open" means: Action on switch closed or High level
"Normal" means: High level, no fault message
"Inverted" means: Low level, no fault message
"+" means: Logical OR combination
Parameter values
FSVL
FSSP
FSAC
0 ... 100
0.0 ... 100.0
0 ... 126
9710
8079
AdAPT
Operating Instructions, 02/2016, A5E00127926-AB
Unit
s
%
SIPART PS2 with PROFIBUS PA