Procedure for installing the internal NCS module
1. You have performed the steps described in the section General information about the
2. Unplug the ribbon cable connector
3. Remove the basic electronics
4. Insert the connector of the ribbon cable (A) into the slot as shown below.
5. Screw the special screw (E) into the shaft of the positioner. Tighten the special screw (E)
6. Press the adjustment wheel of the magnet clamp (F) firmly onto the special screw (E) of
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
installation of option modules (Page 54).
The legend numbers refer to the indicated section. The legend letters refer to the figures
in this section.
⑦
electronics
.
that fasten the basic electronics to the pneumatic block
Note: There is no space for the ribbon cable (A) in earlier versions of the positioner. Here
you fasten the ribbon cable to the container using a cable tie.
with a torque of 2 Nm.
the friction clutch until you clearly hear it click into place.
④
to the installed potentiometer from the basic
⑦
from the positioner. To do this, remove the two screws
Installing/mounting
4.7 Installing the optional modules
⑬
.
71