Siemens SIPART PS2 Operating Instructions Manual page 46

Installing/mounting
4.3 Mounting the part-turn actuator
1. Rest the actuator-specific VDI/VDE 3845 mount
2. Stick the pointer mark
3. Push the coupling wheel
46
Tighten the mount using the hexagon bolts
centering hole.
Pointer mark
positioner shaft. Then retract the coupling wheel or the stainless steel coupling by
approximately 1 mm. Tighten the hexagon socket-head screw
wrench provided. Maximum tightening torque = 1 Nm. If you are using the stainless steel
coupling, omit the next step.
Note
Coupling wheel
Instead of the plastic coupling wheel
(article number TGX: 16300-1556).
Coupling wheel
⑦
⑤
on the mount. Position the pointer mark
Pointer mark, flameproof enclosure
①
or the stainless steel coupling up to the endstop on the
①
, it is possible to use a stainless steel coupling
Coupling wheel, flameproof enclosure
⑥
on the rear side of the positioner.
⑧
and lock washers .
⑤
⑪
using the machinist's
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
at the center of the