Siemens SIPART PS2 Operating Instructions Manual page 43

4. Tighten the screws
5. Fix the pre-installed carrier pin
6. Set the stroke value. Use the stroke value specified on the nameplate of the actuator for
7. Install the following components on the lever
8. Push the pre-installed lever
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
⑰
⑭ ⑱
and hexagon nut
Figure 4-2 Lever with carrier pin
this purpose. If none of the values on the lever scale matches the stroke value of the
actuator, select the next higher value on the scale. Position the pin center
corresponding value of the scale. If you need the value of actuator travel after initialization
in mm: ensure that the configured stroke value matches the value of the "3.YWAY"
parameter.
⑯ ⑫
, flat washer , square nut
Figure 4-3 Components on the lever
⑥
with socket cap screw
so that you can still shift the pick-up bracket
④ ⑥
to the lever
for this purpose.
⑥
⑲
.
⑥
up to the endstop on the positioner shaft. Fasten the lever
⑰
.
4.2 Mounting the linear actuator
②
⑫
. Use the flat washer
⑰
: Socket cap screw
Installing/mounting
.
, spring lock washer
④
on the
, spring lock washer
43