Brick Settings - Sony DVS-9000SF User Manual

Brick Settings

This effect creates a rectangular parallelepiped from 3 successive channels.
For an illustration, see "Global Effects" in Chapter 1 (Volume 1).
Applying the Brick effect
Use the following procedure.
1
In the Global Effect>Ch1 - Ch4 menu, select HF2 'Brick.'
The Brick menu appears.
2
Press [Brick], turning it on.
The Brick effect is enabled, and a rectangular parallelepiped (brick)
showing the images of three channels appears. You can use the knobs to
adjust parameters for the height of the brick and the overlap between the
three images.
Notes
• When the Brick effect is enabled, the z-axis position of the front image
in the source coordinate frame is shifted by the amount of half the height.
Therefore, the image is somewhat magnified.
• The flex shadow function cannot be enabled when Drop Shadow is
enabled.
3
Set the parameters.
Knob
1
2
3
4
4
Specify the way to insert the side images when the height is changed by
pressing one of the following buttons in the <Side V> group or the <Side
H> group.
Crop: Crop the parts that do not fit into the side without shrinking the
picture. You can set the following parameters.
The valid ranges of the parameter values depend on the aspect ratio
(4:3/16:9) selected in the system, as follows.
Parameter
Height
Front Overlap
Side H Overlap
Side V Overlap
Adjustment Setting values
Height of brick 0.00 to 8.00
Front overlap –100.00 to +100.00
Side H overlap –100.00 to +100.00
Side V overlap –100.00 to +100.00
Global Effect Operations
121