Ping Mpls Lsp-End-Point - Dell PowerConnect J-EX4200-24T Software Manual

ping mpls lsp-end-point

Syntax
Release Information
Description
Options
Additional Information
ping mpls lsp-end-point prefix-name
<count count>
<destination address>
<detail>
<exp forwarding-class>
<instance routing-instance-name>
<logical-system (all | logical-system-name)>
<size bytes>
<source source-address>
<sweep>
Command introduced before Junos OS Release 10.2 for J-EX Series switches.
Check the operability of MPLS label-switched path (LSP) endpoint connections. Type
Ctrl+c to interrupt a
ping mpls
count count —(Optional) Number of ping requests to send. If
requests are sent. The range of values is
.
5
destination address —(Optional) Specify an address other than the default (
for the ping echo requests. The address can be anything within the
detail —(Optional) Display detailed information about the echo requests sent and received.
—(Optional) Value of the forwarding class for the MPLS ping packets.
exp forwarding-class
instance routing-instance-name
and forwarding equivalence class (FEC) associated with an LSP connection.
logical-system (all | logical-system-name)
systems or on the specified logical system.
—LDP forwarding equivalence class (FEC) prefix or RSVP LSP endpoint
prefix-name
address.
—(Optional) Size of the LSP ping request packet. If the endpoint is LDP-based,
size bytes
the minimum size of the packet is
minimum size of the packet is
bytes.
65468
source source-address —(Optional) IP address of the outgoing interface. This address is
sent in the IP source address field of the ping request. If this option is not specified,
the default address is usually the loopback interface (
—(Optional) Automatically determine the size of the maximum transmission unit
sweep
(MTU).
If the LSP changes, the label and interface information displayed when you issued the
command continues to be used. You must configure MPLS at the
ping
Chapter 125: Operational Mode Commands for MPLS
command.
through
1 1,000,000
—(Optional) Ping a combination of the routing instance
—(Optional) Perform this operation on all logical
88 bytes. If the endpoint is RSVP-based, the
100 bytes. The maximum size in either case is
count is not specified, five ping
. The default value is
127.0.0.1/32
subnet.
127/8
).
lo.0
[edit protocols
)
3153