Dell PowerConnect J-EX4200-24T Software Manual page 3581

Table 459: show oam ethernet connectivity-fault-management mep-database Output
Fields (continued)
Field Name Field Description
If the MEP is an initiator for a two-way ETH-DM session: Number of valid DMRs received.
Valid DMRs received
For all other cases, this field displays
If the MEP is an initiator for a two-way ETH-DM session: Number of invalid DMRs received.
Invalid DMRs received
For all other cases, this field displays
Remote MEP identifier MEP identifier of the remote MEP.
State of the remote MEP:
State (remote MEP)
MAC address of the remote MEP.
MAC address
Whether the remote MEP MAC address was learned using automatic discovery or configured.
Type
Interface of the remote MEP. A seven-digit number is appended if CFM is configured to run on a routing
Interface
instance of type VPLS.
Date, time, and how long ago the remote MEP interface went from down to up. The format is
Last flapped
flapped: year-month-day hours:minutes:seconds timezone (hours:minutes:seconds ago)
Last flapped: 2002-04-26 10:52:40 PDT (04:33:20 ago)
Whether the remote defect indication (RDI) bit is set in messages that have been received or
Remote defect
transmitted.
indication
Port status TLV
Interface status TLV
Name of the action profile occurrence associated with a remote MEP.
Action profile
When an action profile occurs, displays the last event that triggered it.
Last event
When all the configured and occurred events (under action profile) are cleared, then the action taken
Last event cleared
gets reverted (such as down interface is made up) and the corresponding time is noted and displayed.
Action taken and the corresponding time of the action occurrence.
Action
,
idle start
In the Maintenance domain section, displays the last transmitted port status TLV value.
In the Remote MEP section, displays the last value of port status TLV received from the remote
MEP.
In the Action profile section, displays, the last occurred event
event occurred due to the reception of
In the Maintenance domain section, displays the last transmitted interface status TLV value.
In the Remote MEP section, displays the last value of interface status TLV received from the remote
MEP.
In the Action profile section, if displays, the last occurred event interface-status-tlv event ( either
lower-layer-down or down ). This event occurred due to the reception of either lower or
in the interface status TLV from remote MEP.
Chapter 131: Ethernet OAM Connectivity Fault Management
.
0
0 .
, , or .
ok failed
.
port-status-tlv blocked
blocked value in the port status TLV from remote MEP.
Last
. For example,
event. This
down value
3509