Dell PowerConnect J-EX4200-24T Software Manual page 3228

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Additional Information
Required Privilege
Level
List of Sample Output
Output Fields
3156
manual-bypass —(Optional) Ping manually configured bypass LSPs, used for protecting
other LSPs.
multipoint —(Optional) Send ping requests to each of the egress routers or switches
participating in a point-to-multipoint LSP. You can also include the
ping a specific egress router or switch participating in a point-to-multipoint LSP.
—(Optional) Size of the LSP ping request packet (
size bytes
Packets are 4-byte aligned. For example, if you enter a size of 101, 102, 103, or 104,
the router or switch uses a size value of 104 bytes. If you enter a packet size that is
smaller than the minimum size, an error message is displayed reminding you of the
100-byte minimum.
—(Optional) IP address of the outgoing interface. This address is
source source-address
sent in the IP source address field of the ping request. If this option is not specified,
the default address is usually the loopback interface.
standby standby-path-name
sweep —(Optional) Automatically determine the size of the maximum transmission unit
(MTU).
If the LSP changes, the label and interface information displayed when you issued the
command continues to be used. You must configure MPLS at the
ping
hierarchy level on the remote router or switch to ping an LSP terminating there.
mpls]
You must configure MPLS even if you intend to ping only LDP forwarding equivalence
classes (FECs).
You can configure the ping interval for the
time in seconds using the
hierarchy level. For more information, see the Junos OS MPLS Applications Configuration
Guide at
http://www.juniper.net/techpubs/software/junos/
In asymmetric MTU scenarios, the echo response may be dropped. For example, if the
MTU from System A to System B is 1000 bytes, the MTU from System B to System A is
500 bytes, and the ping request packet size is 1000 bytes, the echo response is dropped
because the PAD TLV is included in the echo response, making it too large.
network
ping mpls rsvp (Echo Reply Received) on page 3157
ping mpls rsvp (Echo Reply with Error Code) on page 3157
ping mpls rsvp detail on page 3157
ping mpls rsvp multipoint egress detail count on page 3157
ping mpls rsvp multipoint detail count on page 3157
ping mpls rsvp destination detail count size on page 3158
ping mpls rsvp destination detail sweep size on page 3158
When you enter this command, you are provided feedback on the status of your request.
An exclamation point ( ! ) indicates that an echo reply was received. A period (
—(Optional) Name of the standby path.
ping mpls rsvp
lsp-ping-interval statement at the
option to
egress
through bytes).
100 65468
[edit protocols
command by specifying a new
[edit protocols mpls oam]
.
. ) indicates