Dell PowerConnect J-EX4200-24T Software Manual page 3145

Table 406: Components of the Ingress PE Switch in Topology for MPLS with Interface-Based
CCC
Property
Local PE switch hardware
Loopback address
Routing protocol
MPLS protocol and definition of
label-switched path
RSVP protocol
Interface family
Customer-edge interface
Core interfaces
CCC definition
Settings
J-EX Series switch
lo0 127.1.1.1/32
ospf traffic-engineering
mpls
label-switched-path lsp_to_pe2_ge1
to 127.1.13
rsvp
family inet
family mpls
family ccc
ge-0/0/1
and with IP
ge-0/0/5.0 ge-0/0/6.0
addresses 10.1.5.1/24 and 10.1.6.1/24
connections
remote-interface-switch ge-1-to-pe2
interface ge-0/0/1.0
transmit-lsp lsp_to_pe2_ge1
receive-lsp lsp_to_pe1_ge1
Chapter 121: Example of MPLS Configuration
Description
PE-1
Identifies PE-1 for interswitch
communications.
Indicates that this switch is using OSPF
as the routing protocol and that traffic
engineering is enabled.
Indicates that this PE switch is using the
MPLS protocol with the specified LSP
to reach the other PE switch (specified
by the loopback address).
The statement must also specify the
core interfaces to be used for MPLS
traffic.
Indicates that this switch is using the
RSVP protocol. The statement must
specify the loopback address and the
core interfaces that will be used for the
RSVP session.
The logical units of the core interfaces
are configured to belong to both
and .
inet family mpls
The logical unit of the customer-edge
interface is configured to belong to
.
family ccc
Interface that connects this network to
devices outside the network.
Interfaces that connect to other
switches within the MPLS network.
Associates the circuit cross-connect
(CCC), ge-0/0/1 , with the LSPs that have
been defined on the local and remote
PE switches.
family
3073