Dell PowerConnect J-EX4200-24T Software Manual page 3089

set interfaces ge-0/0/0 description "wireless access point"
set interfaces ge-0/0/1 description "security camera front door"
set interfaces ge-0/0/2 description "security camera back door"
set interfaces ge-0/0/3 description "emergency phone"
set interfaces ge-0/0/4 description "Executive Office VoIP phone"
set interfaces ge-0/0/5 description "staff VoIP phone"
set interfaces ge-0/0/6 description "staff VoIP phone"
set interfaces ge-0/0/7 description "staff VoIP phone"
Step-by-Step To configure PoE interfaces with different priorities:
Procedure
Set the interfaces connected to high priority powered devices to high priority. Include
1.
the
of power consumption on those interfaces:
[edit poe]
user@switch# set interface ge-0/0/1 priority high telemetries
user@switch# set interface ge-0/0/2 priority high telemetries
user@switch# set interface ge-0/0/3 priority high telemetries
user@switch# set interface ge-0/0/4 priority high telemetries
Provide descriptions for the PoE interfaces:
2.
[edit interfaces]
user@switch# set ge-0/0/0 description "wireless access point"
user@switch# set ge-0/0/1 description "security camera front door"
user@switch# set ge-0/0/2 description "security camera back door"
user@switch# set ge-0/0/3 description "emergency phone"
user@switch# set ge-0/0/4 description "Executive Office VoIP phone"
user@switch# set ge-0/0/5 description "staff VoIP phone"
user@switch# set ge-0/0/6 description "staff VoIP phone"
user@switch# set ge-0/0/7 description "staff VoIP phone"
Connect the wireless access point to interface
3.
default PoE settings.
Connect the two security cameras to interfaces
4.
interfaces are set to high priority with telemetries enabled.
Connect the emergency VoIP phone to interface
5.
high priority with telemetries enabled.
Connect the Executive Office VoIP phone to interface
6.
set to high priority with telemetries enabled.
Connect the staff VoIP phones to
7.
interfaces use the default PoE settings.
Results Check the results of the configuration:
[edit]
user@switch# show
interfaces {
ge-0/0/0 {
description "wireless access point";
unit 0 {
telemetries statement for the high priority interfaces, thus enabling the logging
family ethernet-switching;
Chapter 114: Examples: PoE Configuration
ge-0/0/0. This interface uses the
ge-0/0/1 and
. This interface is set to
ge-0/0/3
ge-0/0/4
ge-0/0/5 , ge-0/0/6 , and ge-0/0/7
ge-0/0/2 . These
. This interface is
. These
3017