Dell PowerConnect J-EX4200-24T Software Manual page 3361

Verification
To confirm that the configuration is correct, perform these tasks:
Verifying That sFlow Technology Has Been Configured Properly on page 3289
Verifying That sFlow Technology Is Enabled on the Intended Interface on page 3289
Verifying the sFlow Collector Configuration on page 3290
Verifying That sFlow Technology Has Been Configured Properly
Purpose Verify that sFlow technology has been configured properly.
Action Use the
show sflow
user@switch> show sflow
sFlow : Enabled
Sample limit
Polling interval : 20 seconds
Sample rate
Agent ID : 10.204.96.222
NOTE: The sample limit cannot be configured and is set to 300
packets/second.
Meaning The output shows that sFlow technology is enabled and specifies the values for the
sample rate, sample limit, and polling interval.
Verifying That sFlow Technology Is Enabled on the Intended Interface
Purpose Verify that sFlow technology is enabled on interfaces and display the sampling
parameters.
Action Use the
show sflow interface
user@switch> show sflow interface
Interface Status
ge-0/0/0.0 Enabled
NOTE: The sample limit cannot be configured and is set to 300
packets/second.
Meaning The output indicates that sFlow technology is enabled on the
a sampling rate of 1000, sampling limit of 300 packets per second and a polling interval
of 20 seconds.
command:
: 300 packets/second
: 1:1000
command:
Sample rate Adapted sample rate
1000 16000
Chapter 127: sFlow Monitoring Technology
Polling-interval
20
interface with
ge-0/0/0.0
3289