Dell PowerConnect J-EX4200-24T Software Manual page 3606

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 463: Match Conditions for the monitor traffic Command (continued)
Match
Type Condition
Directional dst
src
src and dst
or
src dst
Packet
less value
Length
greater value
Protocol
arp
ether
ether [broadcast | multicast]
ether protocol
[address | (arp | ip | rarp)]
icmp
ip
ip [broadcast | multicast]
ip protocol
[address | (icmp | igrp |
tcp | udp)]
isis
rarp
tcp
udp
3534
Description
Matches packets going to the specified destination. This match condition can be
prepended to any of the entity type match conditions.
Matches packets from a specified source. This match condition can be prepended
to any of the entity type match conditions.
Matches packets that contain the specified source and destination addresses.
This match condition can be prepended to any of the entity type match conditions.
Matches packets containing either of the specified addresses. This match condition
can be prepended to any of the entity type match conditions.
Matches packets shorter than or equal to the specified value, in bytes.
Matches packets longer than or equal to the specified value, in bytes.
Matches all ARP packets.
Matches all Ethernet packets.
Matches broadcast or multicast Ethernet frames. This match condition can be
prepended with
Matches packets with the specified Ethernet address or Ethernet packets of the
specified protocol type. The
independent match conditions, so they must be preceded by a backslash (
when used in the
Matches all ICMP packets.
Matches all IP packets.
Matches broadcast or multicast IP packets.
Matches packets with the specified address or protocol type. The
arguments
must be preceded by a backslash (
Matches all IS-IS routing messages.
Matches all RARP packets.
Matches all TCP datagrams.
Matches all UDP datagrams.
To combine expressions, use the logical operators listed in Table 464 on page 3535.
and .
src dst
ether protocol
match condition.
ether protocol
, , and are also independent match conditions, so they
icmp tcp udp
\ ) when used in the
arguments , , and are also
arp ip rarp
ip protocol
ip protocol match condition.
\ )