Dell PowerConnect J-EX4200-24T Software Manual page 3155

J series; j-ex series

Table of Contents

Verifying the Physical Layer on the Switches

Verify that the interfaces are up. Perform this verification task on each of the switches.

user@switchPE-1>

show interfaces terse

interfaces on the switch. This output verifies that the interfaces are

the protocol family (

circuit cross-connect. The output for the protocol family of the core interfaces (

column for the core interfaces shows the IP address configured for these interfaces.

Verifying the Routing Protocol

Verify the state of the configured routing protocol. Perform this verification task on each

of the switches. The state must be

user@switchPE-1> show ospf neighbor

show ospf neighbor

shows that the state is

is, hello packets are being exchanged between directly connected neighbors.

Verifying the Core Interfaces Being Used for the MPLS Traffic

Verify that the state of the MPLS interface is

of the switches.

user@switchPE-1> show mpls interface

interface-name terse

Admin Link Proto

command displays status information about the Gigabit Ethernet

column) shows that interface

), shows that these interfaces are configured as both

command displays the status of the routing protocol. This output

, meaning that the routing protocol is operating correctly—that

Administrative groups

Chapter 121: Example of MPLS Configuration

is configured as a

. Perform this verification task on each

. The output for

Chapters

Table of Contents