Dell PowerConnect J-EX4200-24T Software Manual page 3091

Verification
Purpose
Action
Meaning
Related
Documentation
priority high;
telemetries;
}
interface ge-0/0/4 {
priority high;
telemetries;
}
}
To verify that PoE interfaces have been created and are operational, perform the following
tasks:
Verifying That the PoE Interfaces Have Been Created with the Correct
Priorities on page 3019
Verifying That the PoE Interfaces Have Been Created with the Correct Priorities
Verify that the PoE interfaces on the switch are now set to the correct priority settings.
List all the PoE interfaces configured on the switch:
user@switch> show poe interface
Interface Admin status Oper status Max power Priority Power consumption Class
ge-0/0/0 Enabled ON
ge-0/0/1 Enabled ON
ge-0/0/2 Enabled ON
ge-0/0/3 Enabled ON
ge-0/0/4 Enabled ON
ge-0/0/5 Enabled ON
ge-0/0/6 Enabled ON
ge-0/0/7 Enabled ON
The command lists PoE interfaces configured on the switch, with their
show poe interface
status, priority, power consumption, and class. This output shows that eight PoE interfaces
are enabled. Interfaces ge-0/0/1
remaining PoE interfaces are configured with the default priority value of
Example: Configuring PoE Interfaces on a J-EX Series Switch on page 3013
Configuring PoE (CLI Procedure) on page 3021
Troubleshooting PoE Interfaces on page 3031
Chapter 114: Examples: PoE Configuration
15.4W Low
15.4W High
15.4W High
15.4W High
15.4W High
15.4W Low
15.4W Low
15.4W Low
through ge-0/0/4 are configured as priority
7.9W 0
4.8W 0
4.8W 0
3.3W 2
4.7W 2
3.2W 2
3.3W 2
3.3W 2
high . The
low .
3019