Dell PowerConnect J-EX4200-24T Software Manual page 3266

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 425: show mpls lsp Output Fields (continued)
Field Name Field Description
Received RRO (Ingress LSP) Received record route. A series of hops, each with an address
followed by a flag. (In most cases, the received record route is the same as the
computed explicit route. If
is a topology change in the network, and the route is taking a detour.) The
following flags identify the protection capability and status of the downstream
node:
0x01
protected by a local repair mechanism. This flag can be set only if the Local
protection flag was set in the
corresponding Path message.
0x02
this tunnel (usually because of an outage of the link it was routed over
previously).
0x03
0x04
path providing the same bandwidth guarantee as the protected LSP for the
protected section.
0x08
providing protection against link and node failure on the corresponding path
section. If the downstream routing device can set up only a link-protection
backup path, the
bit is cleared.
0x09
0x10
preemption is in progress for the traffic engine LSP. This flag indicates to the
ingress legacy edge router (LER) of this LSP that it should be rerouted.
0xb
(Ingress LSP) Log entry number of each LSP path event. The numbers are in
Index number
chronological descending order, with a maximum of 50 index numbers displayed.
Date (Ingress LSP) Date of the LSP event.
Time (Ingress LSP) Time of the LSP event.
(Ingress LSP) Description of the LSP event.
Event
(Ingress LSP) Date and time the LSP was created.
Created
(Bypass) RSVP reservation style. This field consists of two parts. The first is the
Resv style
number of active reservations. The second is the reservation style, which can
be FF
Labelin Incoming label for this LSP.
Outgoing label for this LSP.
Labelout
Name of the LSP.
LSPname
3194
Received RRO
—Local protection available. The link downstream from this node is
SESSION_ATTRIBUTE
—Local protection in use. A local repair mechanism is in use to maintain
—Combination of 0x01 and
—Bandwidth protection. The downstream routing device has a backup
—Node protection. The downstream routing device has a backup path
Local protection available
—Detour is established. Combination of
—Preemption pending. The preempting node sets this flag if a pending
—Detour is in use. Combination of
(fixed filter), SE (shared explicit), or
is different from
Computed ERO
object of the
0x02 .
bit is set but the Node protection
0x01 and 0x08 .
, , and .
0x01 0x02 0x08
WF (wildcard filter).
Level of Output
detail extensive
, there
extensive
extensive
extensive
extensive
extensive
brief detail extensive
brief detail
brief detail
brief detail