Dell PowerConnect J-EX4200-24T Software Manual page 3605

Additional Information
Table 463: Match Conditions for the monitor traffic Command
Match
Type Condition
Entity
host {address | hostname
net address
net addressmask mask
port [port-number
| port-name]
Chapter 134: Operational Mode Commands for General Network Management and Monitoring
no-promiscuous —(Optional) Do not put the interface into promiscuous mode.
—(Optional) Suppress reverse lookup of the IP addresses.
no-resolve
—(Optional) Suppress timestamps on displayed packets.
no-timestamp
print-ascii —(Optional) Display each packet in ASCII format.
—(Optional) Display each packet, except the link-level header, in hexadecimal
print-hex
format.
resolve-timeout timeout —(Optional) Amount of time the router or switch waits for each
reverse lookup before timing out. You can set the timeout for between 1 and
4,294,967,295 seconds. The default is 4 seconds. To display each packet, use the
print-ascii , print-hex , or
—(Optional) Read but not display up to the specified number of bytes for each
size size
packet. When set to
brief
for capturing IP, ICMP, UDP, and TCP packet data. When set to
output, the default packet size is 1514. The
displayed packets if the matched data exceeds the configured size.
In the monitor traffic command, you can specify an expression to match by using the
matching option and including the expression in quotation marks:
monitor traffic matching "expression"
Replace with one or more of the match conditions listed in Table 463 on
expression
page 3533.
Description
] Matches packets that contain the specified address or hostname.
The host match condition can be prepended with the protocol match conditions
, , or
arp ip rarp
Matches packets with source or destination addresses containing the specified
network address.
Matches packets containing the specified network address and subnet mask.
Matches packets containing the specified source or destination TCP or UDP port
number or port name.
In place of the numeric port address, you can specify a text synonym, such as
(179), dhcp
extensive option.
output, the default packet size is 96 bytes and is adequate
monitor traffic
, or any of the directional match conditions.
(67), or domain (53) (the port numbers are also listed).
detail and extensive
command truncates
bgp
3533