Dell PowerConnect J-EX4200-24T Software Manual page 3482

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 450: RPM Probe Owner, Concurrent Probes, and Probe Servers Configuration
Fields (continued)
Field
Probe Servers
Table 451: Performance Probe Tests Configuration Fields
Field
Identification
Test Name
Target (Address or URL)
Source Address
Routing Instance
History Size
Request Information
3410
Function
Specifies the servers that act as receivers
and transmitters for the probes.
Function
Identifies the RPM test.
Specifies the IP address or the URL of the
probe target.
Specifies the IP address to be used as the
probe source address.
Specifies the routing instance over which
the probe is sent.
Specifies the number of probe results to
be saved in the probe history.
Your Action
Set up the following servers:
TCP Probe Server—Specifies the port
on which the device is to receive and
transmit TCP probes. Type the
number 7 (a standard TCP port
number) or a port number from 49160
through 65535.
UDP Probe Server—Specifies the port
on which the device is to receive and
transmit UDP probes. Type the
number 7 (a standard TCP port
number) or a port number from 49160
through 65535.
Your Action
Type a test name.
Type the IP address in dotted decimal
notation or the URL of the probe target.
If the target is a URL, type a fully formed
URL that includes .
http://
Type the source address to be used for
the probe. If you do not supply this value,
the packet uses the outgoing interface's
address as the probe source address.
Type the routing instance name. The
routing instance applies only to
and probe types.
icmp-ping-timestamp
The default routing instance is
Type a number from 0 through 255. The
default history size is 50.
icmp-ping
inet.0 .