Dell PowerConnect J-EX4200-24T Software Manual page 3483

Table 451: Performance Probe Tests Configuration Fields (continued)
Field
Probe Type
Interval
Test Interval
Probe Count
Moving Average Size
Destination Port
DSCP Bits
Data Size
Data Fill
Hardware Timestamp
One Way Hardware Timestamp
Function
Specifies the type of probe to send as
part of the test.
Sets the wait time (in seconds) between
probe transmissions.
Sets the wait time (in seconds) between
tests.
Sets the total number of probes to be
sent for each test.
Specifies the number of samples to be
used in the statistical calculation
operations to be performed across a
number of the most recent samples.
Specifies the TCP or UDP port to which
probes are sent.
To use TCP or UDP probes, you must
configure the remote server as a probe
receiver. Both the probe server and the
remote server must be Dell
PowerConnect network devices
configured to receive and transmit RPM
probes on the same TCP or UDP port.
Specifies the Differentiated Services code
point (DSCP) bits. This value must be a
valid 6-bit pattern.
Specifies the size (in bytes) of the data
portion of the ICMP probes.
Specifies the hexadecimal value of the
data portion of the ICMP probes.
Enables one-way hardware timestamp.
Chapter 129: Real-Time Performance Monitoring (RPM)
Your Action
Select a probe type from the list:
http-get
http-get-metadata
icmp-ping
icmp-ping-timestamp
tcp-ping
udp-ping
udp-ping-timestamp
Type a number from 1 through 255 .
Type a number from 0 through 86400 .
Type a number from 1 through 15.
Type a number from 0 through 255.
Type the number 7 (a standard TCP or
UDP port number) or a port number from
49160 through 65535.
Type a valid 6-bit pattern.
Type a number from 0 through 65507.
Type a hexadecimal value from 1h
through 800h .
To enable timestamping, select the check
box.
3411