Dell PowerConnect J-EX4200-24T Software Manual page 3148

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Step-by-Step
Procedure
3076
set protocols mpls interface ge-0/0/5.0
set protocols mpls interface ge-0/0/6.0
set protocols rsvp interface lo0.0
set protocols rsvp interface ge-0/0/5.0
set protocols rsvp interface ge-0/0/6.0
set interfaces lo0 unit 0 family inet address 127.1.1.1/32
set interfaces ge-0/0/5 unit 0 family inet address 10.1.5.1/24
set interfaces ge-0/0/6 unit 0 family inet address 10.1.6.1/24
set interfaces ge-0/0/5 unit 0 family mpls
set interfaces ge-0/0/6 unit 0 family mpls
set interfaces ge-0/0/1 unit 0 family ccc
set protocols connections remote-interface-switch ge-1–to-pe2 interface ge-0/0/1.0
set protocols connections remote-interface-switch ge-1–to-pe2 transmit-lsp lsp_to_pe2_ge1
set protocols connections remote-interface-switch ge-1–to-pe2 receive-lsp lsp_to_pe1_ge1
To configure the local ingress PE switch:
Configure OSPF with traffic engineering enabled:
1.
[edit protocols]
user@switchPE-1# set ospf traffic-engineering
Configure OSPF on the loopback address and core interfaces:
2.
[edit protocols]
user@switchPE-1# set ospf area 0.0.0.0 interface lo0.0
user@switchPE-1# set ospf area 0.0.0.0 interface ge-0/0/5.0
user@switchPE-1# set ospf area 0.0.0.0 interface ge-0/0/6.0
Configure MPLS on the local switch with a label-switched path to the remote egress
3.
PE switch:
[edit protocols]
user@switchPE-1# set mpls label-switched-path lsp_to_pe2_ge1 to 127.1.1.3
Configure MPLS on the core interfaces:
4.
[edit protocols]
user@switchPE-1# set mpls interface ge-0/0/5.0
user@switchPE-1# set mpls interface ge-0/0/6.0
Configure RSVP on the loopback interface and core interfaces:
5.
[edit protocols]
user@switchPE-1# set rsvp interface lo0.0
user@switchPE-1# set rsvp interface ge-0/0/5.0
user@switchPE-1# set rsvp interface ge-0/0/6.0
Configure IP addresses for the loopback interface and core interfaces:
6.
[edit]
user@switchPE-1# set interfaces lo0 unit 0 family inet address 127.1.1.1/32
user@switchPE-1# set interfaces ge-0/0/5 unit 0 family inet address 10.1.5.1/24
user@switchPE-1# set interfaces ge-0/0/6 unit 0 family inet address 10.1.6.1/24
Configure family mpls
7.
[edit]
user@switchPE-1# set interfaces ge-0/0/5 unit 0 family mpls
user@switchPE-1# set interfaces ge-0/0/6 unit 0 family mpls
Configure the logical unit of the customer-edge interface as a CCC:
8.
on the logical unit of the core interface addresses: