Chapter 123 Verifying Mpls - Dell PowerConnect J-EX4200-24T Software Manual

CHAPTER 123
Verifying MPLS
Verifying That MPLS Is Working Correctly
Verifying the Physical Layer on the Switches
Purpose
Action
Meaning
Verifying That MPLS Is Working Correctly on page 3115
Verifying Path Protection in an MPLS Network on page 3118
To verify that MPLS is working correctly on J-EX Series switches, perform the following
tasks:
Verifying the Physical Layer on the Switches on page 3115
1.
Verifying the Routing Protocol on page 3116
2.
Verifying the Core Interfaces Being Used for the MPLS Traffic on page 3116
3.
Verifying RSVP on page 3116
4.
Verifying the Assignment of Interfaces for MPLS Label Operations on page 3117
5.
Verifying the Status of the CCC on page 3117
6.
Verify that the interfaces are up. Perform this verification task on each of the switches.
user@switch> show interfaces ge- terse
Interface
ge-0/0/0
ge-0/0/0.0
ge-0/0/1.0
ge-0/0/2.0
ge-0/0/3.0
ge-0/0/4.0
ge-0/0/5.0
mpls
ge-0/0/6.0
mpls
The command displays status information about the Gigabit Ethernet
show interfaces terse
interfaces on the switch. This output verifies that the interfaces are
the protocol family (
Proto
are configured as circuit cross-connect. The Local and Remote columns do not display
Admin Link Proto Local
up up
up up
up up ccc
up up ccc
up up eth-switch
up up eth-switch
up up inet 10.1.5.1/24
up up inet 10.1.6.1/24
column) shows that interfaces
Remote
. The output for
up
and
ge-0/0/1.0 ge-0/0/2.0
3115