Dell PowerConnect J-EX4200-24T Software Manual page 3094

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 398: PoE Configurable Options and Default Settings (continued)
Option Default
priority low
Not included in default
telemetries
configuration
maximum-power 15.4
support IEEE 802.3af)
30.0
support IEEE 802.3at)
Not included in default
disable
configuration
3022
Description
Sets an interface's power priority to either
insufficient for all PoE interfaces, the low priority interfaces are shut
down before the high priority interfaces. Among interfaces that have the
same assigned priority, the power priority is determined by port
number—with lower- numbered ports having higher priority.
When included in the configuration, enables the logging of power
consumption records on an interface. Logging occurs every five minutes
for one hour unless you specify a different
W (for switches that Sets the maximum power that can be delivered by a PoE interface. The
maximum power allowed is the same as the default—either 15.4 W for
switches that do not support IEEE 802.3at or 30.0 W for switches that
W (for switches that
do support it.
This setting is ignored if the power management mode is
When included in the configuration, disables PoE on the interface. The
interface maintains network connectivity but no longer supplies power
to a connected powered device. Power is not allocated to the interface.
To configure PoE:
To change power management mode from the default class mode to static mode:
1.
[edit poe]
user@switch# set management static
To reserve a specified wattage of power in case of a spike in PoE consumption:
2.
[edit poe]
user@switch# set guard-band 15
To configure a number of interfaces with the same settings (for example, to enable
3.
telemetry collection on all interfaces):
[edit poe]
user@switch# set interface all telemetries
To configure individual interfaces with different settings:
4.
[edit poe]
user@switch# set interface ge-0/0/0 priority high telemetries duration 24
[edit poe]
user@switch# set interface ge-0/0/1
[edit poe]
user@switch# set interface ge-0/0/7 disable
When you configure an individual interface, its configuration overrides any settings
you configure with the
example above retains the default settings regardless of any settings configured with
the
set poe interface all
command. For example,
set poe interface all
command.
low or high . If power is
or
interval duration.
.
class
in the
ge-0/0/1