Dell PowerConnect J-EX4200-24T Software Manual page 3147

Table 408: Components of the Provider Switch in Topology for MPLS with Interface-Based
CCC
Property
Provider switch hardware
Loopback address
Routing protocol
MPLS protocol
RSVP protocol
Interface family
Core interfaces
Configuring the Local PE Switch
CLI Quick
Configuration
Table 408 on page 3075 shows the MPLS configuration components used for the provider
switch in this example.
Settings
J-EX Series switch
lo0 127.1.1.2/32
ospf traffic-engineering
mpls
rsvp
family inet
family mpls
ge-0/0/5.0 and
addresses
10.1.5.1/24
and ae0 with IP address
To quickly configure the local ingress PE switch, copy the following commands and paste
them into the switch terminal window of PE-1:
[edit]
set protocols ospf traffic-engineering
set protocols ospf area 0.0.0.0 interface lo0.0
set protocols ospf area 0.0.0.0 interface ge-0/0/5.0
set protocols ospf area 0.0.0.0 interface ge-0/0/6.0
set protocols mpls label-switched-path lsp_to_pe2_ge1 to 127.1.1.3
Chapter 121: Example of MPLS Configuration
Description
Transit switch within the MPLS network
configuration.
Identifies provider switch for interswitch
communications.
Indicates that this switch is using OSPF
as the routing protocol and that traffic
engineering is enabled.
Indicates that this switch is using the
MPLS protocol.
The statement must specify the core
interfaces that will be used for MPLS
traffic.
Indicates that this switch is using the
RSVP protocol. The statement must
specify the loopback and the core
interfaces that will be used for the RSVP
session.
The logical units for the loopback
interface and core interfaces belong to
family inet
The logical units of the core interfaces
are also configured to belong to
mpls
ge-0/0/6.0 with IP Interfaces that connect the provider
and switch (P) to PE-1.
10.1.6.1/24
10.1.9.1/24
Aggregated Ethernet interface on P that
connects to aggregated Ethernet
interface
.
family
.
of PE-2.
ae0
3075