Aborting A Command - Nortel 325-24T Configuration Manual

72 Chapter 1 About Ethernet Switches 325 and 425
Label
Down

Aborting a command

To abort a command entered using the UI button, do one of the following actions:
•
•
Setting the default IP address
You can set a default IP address and subnet mask for the switch or stack by using
the UI button on the front panel of the Ethernet Switch 425. You can also manage
the switch or stack remotely by using a Default IP address. The default IP address
is 192.168.192.168.
Depending on the mode of operation of the switch (standalone or stack) the
default IP address is applied to the local unit or to the entire stack. When the
Ethernet Switch 425-24T is operating in the stack mode, the UI button on the front
panel on any unit of the stack can be used to set the default IP address. Ensure that
you do not create duplicate IP addresses on the network.
320985-A Rev 01
Color/Status
Green/steady
Amber/blinking
Wait for about 20 seconds after entering either the one-press (set to base unit)
or the two-press (reset to base) and the input is ignored.
Press the UI button 7 or more times, which exits the Configuration mode and
does not change any settings on the switch.
Note: The UI button may be used at any time to change the In-Use IP
address and subnet mask of the switch. It overrides the current In-use IP
address and subnet mask, if any, regardless of the BootP mode settings
for the switch or stack.
Description
The unit is being set as base or non-base unit
using the UI button — base unit has Base
LED on as well.
The stack is reset using the UI button.