Nortel 325-24T Configuration Manual page 121

Chapter 3 CLI Basics 121
The Interface Configuration commands allow you to configure parameters for
each port, such as speed and duplex mode. The Interface Configuration mode is
also referred to as config-if mode.
Figure 26 provides an illustration of the hierarchy of Ethernet Switch 325/425
CLI command modes.
Figure 26 CLI command mode hierarchy
User Exec
(exec)
Privileged EXEC
(privExec)
Global Configuration
(config)
Interface Configuration
(config-if)
10194EA
You can see a specific value for each command mode at the prompt line, and you
can use specific commands to enter or exit each command mode (Table 20).
Additionally, you can only enter command modes from specific modes and only
exit to specific command modes.
System Configuration Guide