Sntp Sync-Now Command - Nortel 325-24T Configuration Manual

sntp sync-now command

The
sntp sync-now
server.
Note: You must have SNTP enabled before this command can take
effect.
The syntax for the
sntp sync-now
The
sntp sync-now
The
sntp sync-now
sntp sync-interval command
The
sntp sync-interval
the NTP server in hours relative to initial synchronization. The syntax for the
sntp sync-interval
sntp sync-interval <0-168>
The
sntp sync-interval
Table 88 describes the parameters and variables for the
command.
Table 88 sntp sync-interval command parameters and variables
Parameters and
variables
<0-168>
Chapter 7 System configuration using the CLI 293
command forces a manual synchronization with the NTP
command is:
sntp sync-now
command is in the config command mode.
command has no parameters or variables.
command specifies recurring synchronization with
command is:
command is in the config command mode.
Description
Enter the number of hours you want for periodic synchronization
with the NTP server.
Note: 0 is boot-time only, and 168 is once a week; the default
value is 24 hours.
sntp sync-interval
System Configuration Guide