Default Lldp Tx-Tlv Command - Nortel 325-24T Configuration Manual

default lldp tx-tlv command

The
default lldp tx-tlv
include in the transmitted LLDPDUs (by default, the optional TLVs are not
included in LLDPDUs). The syntax for the
is:
default lldp tx-tlv [port <portlist>] [port-desc] [sys-name]
[sys-desc] [sys-cap] [local-mgmt-addr]
The
default lldp tx-tlv
Table 97 describes the parameters and variables for the
command.
Table 98 default lldp tx-tlv command parameters and variables
Parameters and
variables
port <portlist>
port-desc
sys-name
sys-desc
sys-cap
local-mgmt-addr
lldp port status command
The
lldp port status
on ports. The syntax for the
lldp port <portlist> status [rxOnly | txAndRx | txOnly]
The
lldp port status
Chapter 7 System configuration using the CLI 305
command specifies the optional TLVs not to
command is in the config-if command mode.
Description
Specifies the ports affected by the command.
Port description TLV. (default value is false: not included)
System name TLV (default value is false: not included)
System description TLV (default value is false: not included)
System capabilities TLV (default value is false: not included)
Local management address TLV (default value is false: not
included)
command sets the LLDPU transmit and receive status
lldp port status
command is in the config-if command mode.
default lldp tx-tlv
default lldp tx-tlv
command is:
System Configuration Guide
command