Table of Contents
Advertisement
70
Chapter 1 About Ethernet Switches 325 and 425
Setting the unit as a standalone unit
To set the unit as a standalone unit using the UI button:
1
2
3
Resetting the stack
To reset the stack using the UI button:
1
2
3
Resetting the unit
To reset the unit at any time, with the UI button, do the following:
1
2
320985-A Rev 01
The color and status of the UI LED returns to steady green once the command
has been accepted. If the command is rejected, the UI LED turns amber
blinking.
Note: Changing the Base Unit does not take effect until you restart the
system.
Press and hold the UI button until the UI LED displays the Green/blinking
status.
Press the UI button 6 times.
Press the UI button and hold it for 3 seconds to confirm the command.
Press the UI button and hold in for three seconds.
The unit is now in configuration mode, and the color and status of the UI LED
turns green blinking.
Press the UI button three times.
The color and status of the Base, Down, and Up LEDs turn amber blinking.
Press the UI button and hold it for three seconds to confirm the command.
Press the UI button for 3 seconds. The switch operates in the Configuration
mode. The UI LED turns green and will blink.
Press UI button 3 times.
Hide quick links:
Advertisement
Table of Contents
