Show Autosave Command - Nortel 325-24T Configuration Manual

Enabling and disabling autosave
The Ethernet Switch 325/425 performs a check every sixty seconds to detect
changes in the configuration file or a new log message in the non-volatile storage.
If any of these two events occurs, the switch automatically saves it's configuration
and the non-volatile log to flash memory. Autosave also automatically saves your
configuration information across reboots.
You can enable or disable this feature. When you disable autosave, changes in the
configuration file are not saved to the flash memory.
This section covers the following commands:
•
•
•
•

show autosave command

The
enabled or disabled. The syntax for the
show autosave
The
The
Figure 107
"show autosave command"
"autosave enable command" on page 288
"no autosave enable command" on page 288
"default autosave enable command" on page 288
Note: You can use the CLI command copy config nvram to force
a manual save of the configuration when autosave is disabled.
command displays the status of the autosave feature, either
show autosave
command is in the privExec command mode.
show autosave
command has no parameters or variables.
show autosave
displays sample output from the
Chapter 7 System configuration using the CLI 287
show autosave
show autosave
command is:
command.
System Configuration Guide