Nortel 325-24T Configuration Manual page 373

Table 141 Interface tab fields for multiple ports (continued)
Field Description
Mtu Size of the largest packet, in octets, that can be sent or received on the
interface.
PhysAddress MAC address assigned to a particular interface.
AdminStatus Current administrative state of the device, which can be one of the
following:
• up
• down
When a managed system is initialized, all interfaces start with
AdminStatus in the up state. AdminStatus changes to the down state
(or remains in the up state) as a result of either management action or
the configuration information available to the managed system.
OperStatus Current operational state of the interface, which can be one of the
following:
• up
• down
• testing
If AdminStatus is up, then OperStatus should be up if the interface is
ready to transmit and receive network traffic. If AdminStatus is down,
then OperStatus should be down. It should remain in the down state if
and only if there is a fault that prevents it from going to the up state. The
testing state indicates that no operational packets can be passed.
LastChange Value of the time the interface entered its current operational state. If
the current state was entered prior to the last reinitialization of the local
network management subsystem, the value is zero.
LinkTrap Specifies whether linkUp/linkDown traps should be generated for this
interface
Speed The estimate bandwidth of the interface in bits per second (bps). For
interfaces that do not vary in bandwidth or have no way to estimate the
bandwidth, this object should contain the nominal bandwidth. If the
bandwidth of the interface is greater than the maximum value reported
by the object, then the object displays its maximum value
(4,294,967,295). For a sub-layer that has no concept of bandwidth, the
object should be zero.
AutoNegotiate Indicates whether the port is enabled (checked) for autonegotiation or
not.
AdminDuplex The current administrative duplex mode of the port (half or full).
OperDuplex Indicate current duplex value of the port.
AdminSpeed Set the speed of a port: none, mbps10, and mbps100
OperSpeed The current operating speed of the port.
Chapter 10 Configuring ports using Device Manager 373
System Configuration Guide