Show Interfaces Command - Nortel 325-24T Configuration Manual

show interfaces command

The
of all interfaces. The syntax for the
show interfaces [names] [<portlist>]
The
Table 83
command.
Table 83 show interfaces command parameters and variables
Parameters and
variables
names <portlist>
Figure 104
command.
Figure 104 show interfaces names command output
425_48T SW 1.1 in SC2-02 LAB>show interfaces names 1-3
Port Name
---- ----------------------------------------------------------------
1 LabBldg4
2 Testing
3 Floor1Bldg2
425_48T#
Figure 105
the names variable.
show interfaces
show interfaces
describes the parameters and variables for the
Description
Displays the interface names; enter specific ports if you want to
see only those.
displays a sample output of the
Shows a sample output of the
Chapter 7 System configuration using the CLI 283
command displays the current configuration and status
show interfaces
command is in the exec command mode.
show interfaces names
show interfaces
command is:
show interfaces
command without
System Configuration Guide