Common Procedures; Abandoning A Command; Abandoning A Command Entered Using The Ui Button; Nn47200-300 04.03 13 April - Nortel BayStack 5520-48T-PWR Install Manual

.

Common procedures

This module contains procedures that are common to more than one
product line.

Abandoning a command

This procedure describes how to abandon a command entered using the
UI button.
•

Abandoning a command entered using the UI button

Procedure Steps
Step
1
2
Copyright © 2008–2009 Nortel Networks
Action
Wait approximately twenty seconds after entering the command
(without confirming it) and the input is ignored.
Exit configuration mode by pressing the UI button nine or more
times.
Note: Wait sixty seconds after the last configuration change
before resetting the unit. The system can take up to this long to
save configuration changes to the NVRAM. Stacks can be reset
immediately after the last configuration change without any loss
of information.

ERS 5000 Series Installation

NN47200-300 04.03
13 April 2009
--End--
95