Managing Mac Address Forwarding Database Table - Nortel 325-24T Configuration Manual

Figure 35
Figure 35 show stacking-mode command output
425-24T>show stacking-mode
Current mode for unit 1 is stackable, base unit set.
Next mode for unit 1 is stackable, base unit set.
Current mode for unit 2 is stackable, base unit not set.
Next mode for unit 3 is stackable, base unit not set.
Next mode will be applied after reset
renumber unit command
This command is applicable only to Ethernet Switch 425-24T, in its stacked
mode.
The
stack. The syntax for the
renumber unit
The
The

Managing MAC address forwarding database table

This section describes the commands to view the contents of the MAC address
forwarding database table, as well as setting the age-out time for the addresses.
The following topics are covered:
•
•
•
displays sample output from the
command changes the unit number of each switch in the
renumber unit
command is in the config command mode.
renumber unit
command has no parameters or variables.
renumber unit
Note: This command does not take effect until you reset the stack.
"show mac-address-table command" on page 144
"mac-address-table aging-time command" on page 145
"default mac-address-table aging-time command" on page 146
show stacking-mode
command is:
renumber unit
Chapter 3 CLI Basics 143
command.
System Configuration Guide