Table of Contents
Advertisement
Chapter 9 Configuring the switch using Device Manager 345
Table 129 System tab fields (continued)
Field
AuthenticationTraps
ReBoot
AutoPVID
NextBootMgmtProtocol
CurrentMgmtProtocol
BootMode
ImageLoadMode
CurrentImageVersion
LocalStorageImageVersion The version number of the agent image that is stored in
NextBootDefaultGateway
CurrentDefaultGateway
Description
Click to enable or disable. When you enable, SNMP traps
are sent to trap receivers for all SNMP access
authentication. When you disable, no traps are received.
To view traps, click the Trap toolbar button.
By default, the switch will be in the Running mode. The
reboot command initiates a hardware reset.
Click to enable or disable. When you enable, AutoPVID is
activated. When you disable, AutoPVID is inactivated.
The transport protocol(s) to use after the next boot of the
agent.
The current transport protocol(s) that the agent supports.
This setting determines how the management interface of
the switch will be assigned an IP address, the next time the
switch boots. The four BootMode options are:
•
local - use the IP address contained in the configuration
file.
•
net - always attempt to get an IP address from the
network.
•
netWhenNeeded - attempt to get an IP address from the
network only when one is not contained in the
configuration file.
•
netOrLastAddress - attempt to get an IP address from
the network and if that fails use the IP address that was
in use on this switch before the last reboot.
The source from which the agent image is loaded at the
next boot.
The version number of the agent image that is currently
used on the switch.
flash memory on the switch.
The IP address of the default gateway for the agent to use
after the next time the switch is booted.
The IP address of the default gateway that is currently in
use.
System Configuration Guide
Hide quick links:
Advertisement
Table of Contents
