Changing The Ethernet Switch 325/425 To System Defaults - Nortel 325-24T Configuration Manual

2

Changing the Ethernet Switch 325/425 to system defaults

You can change a standalone switch, a specific unit in a stack configuration, or an
entire stack, replacing all configured switch parameters with the factory default
values.
During the process of changing to default settings, the switch initiates a self-test
that comprises various diagnostic routines and subtests. The LEDs display various
patterns to indicate that the subtests are in progress.
To change the Ethernet Switch 325/425 to system defaults:
1
Figure 155 Reset to Default page message
Chapter 11 Administering the switch using Web-based management
Click Submit. If you do not click Submit, any changes you make will be lost.
Note: If you have not configured system password security, a reset
returns you to the home page, as shown in
have configured system password security, a reset returns you to a log on
page (for details on configuring management passwords, see
Configuring and Managing Security for Nortel Ethernet Switches
325 and 425, Software Release 3.6 (320988-A)).
Caution: If you choose change to default settings, all configured
settings are replaced with factory default settings when you click
Submit. For more information about factory default settings, see
Appendix C, "Default settings," on page
From the main menu, choose Administration > Reset to Default.
The reset to default warning message displays
Figure 72 on page 200. If you
431.
(Figure 155).
System Configuration Guide
381