Stack Operation - Nortel 325-24T Configuration Manual

As shown in
backbone switch, connecting to the Ethernet Switch 425 with an optional
(1000BASE-SX) GBIC for maximum bandwidth. The Ethernet Switch 425-24T
and the Ethernet Switch 325-24T have 100 Mb/s connections to the Ethernet
Switch 425-24T, a 100BASE-TX hub, and a 100 Mb/s server as well as 10 Mb/s
connections to DTE (data terminal equipment).
Figure 14 Configuring power workgroups and a shared media hub
Ethernet Routing Switch 8600

Stack operation

You can connect up to eight units of the Ethernet Switch 425-24T and Ethernet
Switch 425-48T to provide uninterrupted connectivity for up to 392 ports. The
entire stack can be managed as a single unit with a single IP and MAC address
You can select the base unit of the stack by using the momentary switch
mechanism. It is recommended that you use only one base unit in the stack and the
selection of the same should be done before powering the stack.
Figure 14, the Ethernet Routing Switch 8600 switch is used as a
Ethernet Switch
425-24T
F
CPU PS1 PS2 FAN
Server
Key
10 Mb/s
100 Mb/s
1000 Mb/s
(Gigabit)
Chapter 1 About Ethernet Switches 325 and 425
Ethernt Switch 325-24G
LED Status - Amber:10Mps Green:100 Mps Blink:Activity
26 25
1 2
UI
Spd Act Spd Act
UI Cmd
Pwr Spd: 10/100/1000T Act: Activity
UI Set
LED Status - Amber:10Mps Green:100 Mps Blink:Activity
26 25
1
UI
Spd Act Spd Act
UI Cmd
Pwr
Spd: 10/100/1000T Act: Activity
UI Set
LED Status - Off:Half Duplex Green:Full Duplex Ethernet Switch 325-24G
3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 Console
Ethernet Switch 325-24G
LED Status - Off:Half Duplex Green:Full Duplex
2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 Console
System Configuration Guide
87