Setting The Default Management Interface - Nortel 325-24T Configuration Manual

The
copy tftp config
Table 79 describes the parameters and variables for the
command.
Table 79 copy tftp config command parameters and variables
Parameters and
variables
address
<XXX.XXX.XXX.XXX>
filename <WORD>

Setting the default management interface

You can use
when you connect to Ethernet Switches 325 and 425 through console port or
Telnet. This selection is stored in NVRAM and propagated to all units in a stack
configuration.
On startup, the switch or stack displays the banner and prompts the user to press
[Ctrl}+y. After entering these characters, the system displays either a menu or the
Nortel Command Line Interface (NCLI) prompt, depending on which is set using
this command.
When using the console port, you must logout for the new mode to display. When
using Telnet, all subsequent Telnet sessions display the selection.
cmd-interface command
The
cmd-interface
interface when you use the console port or Telnet.
The syntax for the
cmd-interface {cli|menu}
The
cmd-interface
Chapter 7 System configuration using the CLI 279
command is in the privExec command mode.
Description
Specifies the TFTP server IP address; enter in dotted-decimal
notation.
Enter the name of the configuration file you want to copy from
the TFTP server.
command to set the default management interface
cmd-interface
command allows you to set the default management
cmd-interface
command is in the privExec command mode.
copy tftp config
command is:
System Configuration Guide