Ip Default-Gateway Command - Nortel 325-24T Configuration Manual

254 Chapter 7 System configuration using the CLI

ip default-gateway command

The
switch or a stack. The syntax for the
ip default-gateway <XXX.XXX.XXX.XXX>
The
Table 60
command.
Table 60 ip default-gateway command parameters and variables
Parameters and
variables
XXX.XXX.XXX.XXX Enter the dotted-decimal IP address of the default IP gateway.
no ip default-gateway command
The
zeros (0). The syntax for the
no ip default-gateway
The
320985-A Rev 01
Note: When you change the IP address or subnet mask, you may lose
connection to Telnet and the Web. You also disable any new Telnet
connection, and you must connect to the serial console port to configure
a new IP address.
ip default-gateway
ip default-gateway
describes the parameters and variables for the
Description
Note: When you change the IP gateway, you may lose connection to
Telnet and the Web.
no ip default-gateway
no ip default-gateway
command sets the IP default gateway address for a
ip default-gateway
command is in the config command mode.
command sets the IP default gateway address to
no ip default-gateway
command is in the config command mode.
command is:
ip default-gateway
command is: